5/30/2023 0 Comments Laser cut 5.3 downloadThen, I had to use psexec to run the software as admin - never could get it to work as a standard user. This is a right pain in the behind, and if the dongle is plugged into a different USB port at any point it can all fall apart. We only run 圆4 versions of Windows, for which there is a driver but it's unsigned and Windows 7 won't allow it to install unless the OS is run in Test Mode, permanently. Fast forward to our migration to Windows 7, and it was a total nightmare to get working. We originally set this up on Windows XP, which was fine but the drivers for the dongle were unsigned. The software requires the 'softdog'(!) to be plugged in to load. ![]() The whole setup is diabolical - I'll give you our scenario: We have one of these Chinese laser cutters, it works with Eas圜ut or LaserCut (which is just the newer version of the software).
0 Comments
Leave a Reply. |